高手请指教－－多线路－输出流量负载均衡

长通网络

首先感谢wsgtrsys 我已经按照手册配置了双线输出的流量负载均衡，使用也很正常游戏也没有发现掉线等情况请教各位高手如何做4线路输出流量负载均衡改如何设置？lan_net = "192.168.0.0/24"int_if = "dc0"ext_if1 = "fxp0"ext_if2 = "fxp1"ext_gw1 = "68.146.224.1"ext_gw2 = "142.59.76.1"# nat outgoing connections on each internet interfacenat on $ext_if1 from $lan_net to any -> ($ext_if1)nat on $ext_if2 from $lan_net to any -> ($ext_if2)# default denyblock in from any to anyblock out from any to any# pass all outgoing packets on internal interfacepass out on $int_if from any to $lan_net# pass in quick any packets destined for the gateway itselfpass in quick on $int_if from $lan_net to $int_if# load balance outgoing tcp traffic from internal network.pass in on $int_if route-to \{ ($ext_if1 $ext_gw1), ($ext_if2 $ext_gw2) } round-robin \proto tcp from $lan_net to any flags S/SA modulate state# load balance outgoing udp and icmp traffic from internal networkpass in on $int_if route-to \{ ($ext_if1 $ext_gw1), ($ext_if2 $ext_gw2) } round-robin \proto { udp, icmp } from $lan_net to any keep state# general "pass out" rules for external interfacespass out on $ext_if1 proto tcp from any to any flags S/SA modulate statepass out on $ext_if1 proto { udp, icmp } from any to any keep statepass out on $ext_if2 proto tcp from any to any flags S/SA modulate statepass out on $ext_if2 proto { udp, icmp } from any to any keep state# route packets from any IPs on $ext_if1 to $ext_gw1 and the same for# $ext_if2 and $ext_gw2pass out on $ext_if1 route-to ($ext_if2 $ext_gw2) from $ext_if2 to anypass out on $ext_if2 route-to ($ext_if1 $ext_gw1) from $ext_if1 to any请教各位高手如何做4线路输出流量负载均衡改如何设置？

长通网络

做4线路输出流量均衡这里怎样写# route packets from any IPs on $ext_if1 to $ext_gw1 and the same for# $ext_if2 and $ext_gw2pass out on $ext_if1 route-to ($ext_if2 $ext_gw2) from $ext_if2 to anypass out on $ext_if2 route-to ($ext_if1 $ext_gw1) from $ext_if1 to any

liaofei1

这个能用在mono路由里面吗?

edwardj

no.mono uses ipf, which does not support this feature

suntory

?教一下您使用的系?是哪一套?PFSENSE 可以使用您的配置??您指的手?是哪??方便分享??

edwardj

QUOTE (suntory @ May 22 2005, 04:21 PM)
?教一下您使用的系?是哪一套?
pf runs on freebsd and openbsd

QUOTE (suntory @ May 22 2005, 04:21 PM)
PFSENSE 可以使用您的配置??
i don't think so, 'cause pfsense has its own rule generating system

QUOTE (suntory @ May 22 2005, 04:21 PM)
您指的手?是哪??方便分享??
http://www.routerclub.com/ipb/index.php?showtopic=5236

suntory

thanks for the advice.i am tring in this pfsense 0.62.1-PFThreeDotSeven system now他有 firewall_nat_out_load_balancing的功能不过 除了 WAN PORT有支援PPPOE外 OPT1 OPT2 仅支援 固定IP不晓的您有用过吗因为我的环境并无 双WAN的线路 不过我很想试试看是否能使用

suntory

补充一下如果 2WAN可以用的话  相信 4WAN也可以?因为 PFS可以支援多网卡