{求助} 做完NTH负载平衡后 路由重启ADSL找不到网关??

seahifi

环境: ros2.9.27
wan1: interface=ether2 (ADSL动态拨号)
wan2: interface=ether3 (ADSL固定IP)

按网上的教程安全完成后
发现重启路由后 重新捕获的ether2网关是ADSL新IP 不是新网关

需要把新IP改成新网关后 才能正常

ADSL长时间断线后 再重拨 一样的问题
脚本如下
:local assign-address
:local new-address
:local status
:local adckip
:local new-gateway
:local x
:set x 1
:for i from=1 to=$x do={
    :set status [/interface get [/interface find  name=("pppoe-out" . $i)] running]
    :if ($status=true) do={
     :set new-address [/ip address get [/ip address find dynamic=yes interface=("pppoe-out" . $i)] address]
     :set new-address [:pick $new-address 0 ([:len $new-address] -3)]
     :set assign-address [/ip address get [/ip address find dynamic=no interface=("pppoe-out" . $i)] address]
     :set assign-address [:pick $assign-address 0 ([:len $assign-address] -3)]
     :set new-gateway [/ip address get [/ip address find dynamic=yes interface=pppoe-out1] network]
     :set adckip [/tool netwatch get [/tool netwatch find comment=$i] host]
     :if ($assign-address != $new-address) do={ /ip address set [/ip address find comment=$i] address=$new-address network=$new-address broadcast=$new-address
        /ip route set [/ip route find comment=$i] gateway=$new-address
        /ip fir nat set [/ip fir nat find comment=$i] to-addresses=$new-address
       }
     :if ($new-gateway != $adckip) do={/tool netwatch set [/tool netwatch find comment=$i] host=$new-gateway]
       }
   }
}

怎么办??
求助哇
  

seahifi

seahifi

:'):'):')

seahifi

....................