bysoft
发表于 2005-4-4 10:29:42
Fastethernet0IP address 222.180.XX.XXX 255.255.255.252ip nat outside！Fastethernet1IP address 192.168.0.254 255.255.255.0ip nat inside！Fastethernet2IP addredd 192.168.1.254 255.255.255.0ip nat inside！Fastethernet3IP address 192.168.2.254 255.255.255.0ip nat inside！accress-list 1 permit anyip route 0.0.0.0 0.0.0.0 222.180.xx.xxx（这是网关地址）请问如此配置为什么不能通过NAT转换上网？请各位老师指教一下
bysoft
发表于 2005-4-4 10:39:24
QUOTE (bysoft @ Apr 4 2005, 10:29 AM)
Fastethernet0IP address 222.180.XX.XXX 255.255.255.252（广域网接口）ip nat outside！Fastethernet1IP address 192.168.0.254 255.255.255.0ip nat inside！Fastethernet2IP addredd 192.168.1.254 255.255.255.0ip nat inside！Fastethernet3IP address 192.168.2.254 255.255.255.0ip nat inside！accress-list 2 permit anyip route 0.0.0.0 0.0.0.0 222.180.xx.xxx（这是网关地址）请问如此配置为什么不能通过NAT转换上网？请各位老师指教一下
请问是不是还要加上ip nat inside source list 2 interface fastethernet0
bysoft
发表于 2005-4-5 19:59:14
已经搞定！原来是子网分割的问题！
samhui
发表于 2005-8-12 18:46:28
哈哈。。和cisco很像呀
页:
[1]