SXT 5HnD 下雨天的情况信号速度有所变化
前两天发了一个粘子说，这个SXT 5HnD 的问题主要是延迟这一块的问题我用RouterOS SXT 的产品主要是看他的体积小。不过话说回来，这东西一般的人还真用不来，当然我也不很懂这个东西，不过经这么几天的研究也了解一些，玩这个东西的朋友应该知道，一般在使用中都是在家里先调好然后在拿到外面去安装，很多的时候发现调这个东西是比较嘛烦的，而且他的一些性能效果波动还是比较大的。
今天把这些东西发上来大家一起来研究让RouterOS SXT 产品能正能发挥出他的性能来。
相信很多的朋友，有的是不敢买怕买了自己不会用，还有的是买了后回来不知道怎么用，说到这块很多朋友也是想RouterOS 的东西要去培训。像有的用户他买一对半对的也要去培训一这个也不现实。
话不多说上图
发射的参数
PING到接收网桥的IP
接收网桥
你多大带宽测试应用啊？ 这东西把信号反向锅盖天线，效果应该响当当。。 greney 发表于 2012-4-19 14:56 static/image/common/back.gif
你的CCQ怎么那么好，你的距离多远的 你的QQ号多少，我的394193099 peckpock 发表于 2012-4-19 15:21 static/image/common/back.gif
这东西把信号反向锅盖天线，效果应该响当当。。
您說的是不是這樣？;P;P;P
楼主你那白色的脚架多少钱买的啊？在什么地方买得到？ szhefeng 发表于 2012-4-19 16:38 static/image/common/back.gif
你的QQ号多少，我的394193099
沒多遠，也就十來公里的樣子吧...:D
順便送上改造過的的柵格 可以借鑒
liusimin 发表于 2012-4-19 22:13 static/image/common/back.gif
沒多遠，也就十來公里的樣子吧...
順便送上改造過的的柵格 可以借鑒
mikrotik无线比UBNT好用？怎么看到你们都在用mikrotik的 最後，再幫LZ答疑解惑一下
後面附上我個人的配置文件！
配置INFO
/ip address
add address=192.168.1.1/24 broadcast=192.168.1.255 comment="" disabled=no interface=wlan1 network=192.168.1.0
/interface wireless
set 0 ack-timeout=dynamic adaptive-noise-immunity=none allow-sharedkey=no antenna-gain=0 antenna-mode=ant-a area="" arp=enabled band=2ghz-b/g/n basic-rates-a/g=6Mbps \
basic-rates-b=1Mbps comment="" compression=no country=no_country_set default-ap-tx-limit=0 default-authentication=yes default-client-tx-limit=0 default-forwarding=\
yes dfs-mode=none disable-running-check=no disabled=no disconnect-timeout=3s frame-lifetime=0 frequency=2412 frequency-mode=manual-txpower hide-ssid=no \
ht-ampdu-priorities=0 ht-amsdu-limit=8192 ht-amsdu-threshold=8192 ht-basic-mcs=mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7 ht-extension-channel=above-control \
ht-guard-interval=any ht-rxchains=0,2 ht-supported-mcs=mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,mcs-9,mcs-10,mcs-11,mcs-12,mcs-13,mcs-14,mcs-15 \
ht-txchains=0,2 hw-fragmentation-threshold=disabled hw-protection-mode=none hw-protection-threshold=0 hw-retries=4 mac-address=00:1D:0F:BB:8C:66 max-station-count=\
2007 mode=ap-bridge mtu=1500 name=wlan1 periodic-calibration=default periodic-calibration-interval=60 preamble-mode=both \
proprietary-extensions=post-2.9.25 radio-name=001D0FBB8C66 rate-set=default scan-list=default security-profile=default ssid=abc station-bridge-clone-mac=\
00:00:00:00:00:00 supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,54Mbps supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps tx-power-mode=default \
wds-mode=disabled wmm-support=enabled
配置info
/ip address
add address=192.168.1.2/24 broadcast=192.168.1.255 comment="" disabled=no interface=wlan1 network=192.168.1.0
/interface wireless
set 0 ack-timeout=dynamic adaptive-noise-immunity=none allow-sharedkey=no antenna-gain=0 antenna-mode=ant-a area="" arp=enabled band=2ghz-b/g/n basic-rates-a/g=6Mbps \
basic-rates-b=1Mbps comment="" compression=no country=no_country_set default-ap-tx-limit=0 default-authentication=yes default-client-tx-limit=0 default-forwarding=\
yes dfs-mode=none disable-running-check=no disabled=no disconnect-timeout=3s frame-lifetime=0 frequency=2412 frequency-mode=manual-txpower hide-ssid=no \
ht-ampdu-priorities=0 ht-amsdu-limit=8192 ht-amsdu-threshold=8192 ht-basic-mcs=mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7 ht-extension-channel=above-control \
ht-guard-interval=any ht-rxchains=0,2 ht-supported-mcs=mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,mcs-9,mcs-10,mcs-11,mcs-12,mcs-13,mcs-14,mcs-15 \
ht-txchains=0,2 hw-fragmentation-threshold=disabled hw-protection-mode=none hw-protection-threshold=0 hw-retries=4 mac-address=00:1D:0F:BB:8C:1E max-station-count=\
2007 mode=station mtu=1500 name=wlan1 periodic-calibration=default periodic-calibration-interval=60 preamble-mode=both \
proprietary-extensions=post-2.9.25 radio-name=001D0FBB8C1E rate-set=default scan-list=default security-profile=default ssid=abc station-bridge-clone-mac=\
00:00:00:00:00:00 supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,54Mbps supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps tx-power-mode=default \
wds-mode=disabled wmm-support=enabled
配置INFO
/interface wireless security-profiles
set default authentication-types="" eap-methods=passthrough group-ciphers="" \
group-key-update=5m interim-update=0s management-protection=disabled \
management-protection-key="" mode=none name=default \
radius-eap-accounting=no radius-mac-accounting=no \
radius-mac-authentication=no radius-mac-caching=disabled \
radius-mac-format=XX:XX:XX:XX:XX:XX radius-mac-mode=as-username \
static-algo-0=none static-algo-1=none static-algo-2=none static-algo-3=\
none static-key-0="" static-key-1="" static-key-2="" static-key-3="" \
static-sta-private-algo=none static-sta-private-key="" \
static-transmit-key=key-0 supplicant-identity=MikroTik tls-certificate=\
none tls-mode=no-certificates unicast-ciphers="" wpa-pre-shared-key="" \
wpa2-pre-shared-key=""
/interface wireless
set 0 ack-timeout=dynamic adaptive-noise-immunity=none allow-sharedkey=no \
antenna-gain=0 antenna-mode=ant-a area="" arp=enabled band=5ghz-onlyn \
basic-rates-a/g="" basic-rates-b="" comment="" compression=no country=\
no_country_set default-ap-tx-limit=0 default-authentication=yes \
default-client-tx-limit=0 default-forwarding=yes dfs-mode=none \
disable-running-check=no disabled=no disconnect-timeout=3s \
frame-lifetime=0 frequency=5180 frequency-mode=manual-txpower hide-ssid=\
no ht-ampdu-priorities=0,1,2,3,4,5,6,7 ht-amsdu-limit=8192 \
ht-amsdu-threshold=8192 ht-basic-mcs=mcs-0 ht-extension-channel=disabled \
ht-guard-interval=any ht-rxchains=0,1 ht-supported-mcs=\
mcs-0,mcs-7,mcs-8,mcs-14,mcs-15 ht-txchains=0,1 \
hw-fragmentation-threshold=disabled hw-protection-mode=none \
hw-protection-threshold=0 hw-retries=15 mac-address=00:0C:42:3A:CF:E9 \
max-station-count=2 mode=bridge mtu=1500 name=wlan1 on-fail-retry-time=\
100ms periodic-calibration=disabled periodic-calibration-interval=60 \
preamble-mode=short proprietary-extensions=post-2.9.25 radio-name=\
000C423ACFE9 rate-set=configured scan-list=5180,5760,5320,5825 \
security-profile=default ssid=awmn-2315-3665 station-bridge-clone-mac=\
00:00:00:00:00:00 supported-rates-a/g="" supported-rates-b="" tx-power=3 \
tx-power-mode=all-rates-fixed update-stats-interval=disabled \
wds-cost-range=50-150 wds-default-bridge=none wds-default-cost=100 \
wds-ignore-ssid=no wds-mode=disabled wmm-support=enabled
/interface wireless manual-tx-power-table
set wlan1 comment="" manual-tx-powers="1Mbps:17,2Mbps:17,5.5Mbps:17,11Mbps:17,\
6Mbps:17,9Mbps:17,12Mbps:17,18Mbps:17,24Mbps:17,36Mbps:17,48Mbps:17,54Mbps\
:17,HT20-1:0,HT20-2:0,HT20-3:0,HT20-4:0,HT20-5:0,HT20-6:0,HT20-7:0,HT20-8:\
0,HT40-1:0,HT40-2:0,HT40-3:0,HT40-4:0,HT40-5:0,HT40-6:0,HT40-7:0,HT40-8:0"
/interface wireless nstreme
set wlan1 comment="" disable-csma=no enable-nstreme=yes enable-polling=yes \
framer-limit=3998 framer-policy=best-fit
/interface wireless align
set active-mode=yes audio-max=-20 audio-min=-100 audio-monitor=\
00:00:00:00:00:00 filter-mac=00:00:00:00:00:00 frame-size=300 \
frames-per-second=25 receive-all=no ssid-all=no
/interface wireless sniffer
set channel-time=200ms file-limit=10 file-name="" memory-limit=10 \
multiple-channels=no only-headers=no receive-errors=no streaming-enabled=\
no streaming-max-rate=0 streaming-server=0.0.0.0
/interface wireless snooper
set channel-time=200ms multiple-channels=yes receive-errors=no
你做的这个还真不错，我想问一下你的这个他们之间PING 延迟多少， szhefeng 发表于 2012-4-19 22:34 static/image/common/back.gif
你做的这个还真不错，我想问一下你的这个他们之间PING 延迟多少，
本帖最后由 szhefeng 于 2012-4-19 22:57 编辑
很奇怪，我的开NV2延迟就大，后来改用nstreme就小下来了
szhefeng 发表于 2012-4-19 22:55 static/image/common/back.gif
很奇怪，我的开NV2延迟就大，后来改用nstreme就小下来了
PS:不回了，累了.......
页:
[1]
2